Update RN-131C firmware

FTP Update

Important

  1. To proceed you need a UART interface (3,3V level only) to connect WIFIxpresso to your pc. This interface is not provided.
  2. Requires Wi-Fi network with internet access!
  1. Starting from Pass-Through Mode, type following commands to update RN-131C firmware:
  2. Restore module to factory defaults, type these commands:
$$$
factory R
save
reboot
  1. Associate to Internet-Connected Network your network
$$$
scan
set wlan ssid <insert here your ssid>
set wlan pass <insert here your password>
save
reboot
  1. Update firmware and verify the version number
$$$
ftp update
ver
reboot
$$$
ver
  1. After downloading new firmware it is recommended restore module to factory defaults one more time before using it
$$$
factory R
save
reboot